Find recalls for your vehicle

Notes: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.

Recall #02V147000 (05/29/2002)

  • Component: ELECTRICAL SYSTEM:WIRING:FRONT UNDERHOOD
  • Summary: ON CERTAIN PASSENGER VEHICLES, ROUTING OF THE VEHICLE'S FRONT HARNESS CAN ALLOW IT TO COME IN CONTACT WITH A ROUGH EDGE, ALLOWING ABRASION. THIS COULD RESULT IN GROUNDED CIRCUITS.
  • Consequence: THERE COULD BE A LOSS OF STOP OR TURN SIGNAL LAMP OPERATION OR ENGINE HESITATION.
  • What owners should do: DEALERS WILL INSTALL A PROTECTOR, ELIMINATING ANY HARNESS CONTACT. OWNER NOTIFICATION BEGAN JULY 8, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT MITSUBISHI AT 1-800-222-0037.

Recall #01V295001 (09/25/2001)

  • Component: STEERING:HYDRAULIC POWER ASSIST:HOSE, PIPING, AND CONNECTIONS
  • Summary: VEHICLE DESCRIPTION: PASSENGER VEHICLES BUILT WITH V6 ENGINES TO FEDERAL EMISSION STANDARDS. THE POWER STEERING FLUID FEED TUBE CAN COME IN CONTACT WITH AN EXHAUST MANIFOLD MOUNTED HEAT SHIELD CAUSING A HOLE TO BE WORN THROUGH THE POWER STEERING PIPE ALLOWING FLUID LEAKAGE.
  • Consequence: LEAKING POWER STEERING FLUID CAN RESULT IN A FIRE AND CONTINUED LOSS OF FLUID WILL RESULT IN A LOSS OF POWER ASSIST, INCREASING THE RISK OF A CRASH.
  • What owners should do: DEALERS WILL REPLACE THE POWER STEERING TUBE WITH ONE HAVING A NEW ROUTING. OWNER NOTIFICATION BEGAN NOVEMBER 26, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT MITSUBISHI AMERICA AT 1-800-222-0037.

Recall #01V069000 (03/08/2001)

  • Component: FUEL SYSTEM, GASOLINE:STORAGE:TANK ASSEMBLY
  • Summary: VEHICLE DESCRIPTION: PASSENGER VEHICLES. A BULGE IN THE FUEL TANK CAUSED BY THE MANUFACTURING PROCESS RESULTED IN THINNING OF THE MATERIAL DURING A WELDING OPERATION, INCREASING THE RISK OF FUEL LEAKAGE.
  • Consequence: FUEL LEAKAGE IN THE PRESENCE OF AN IGNITION SOURCE COULD RESULT IN A FIRE.
  • What owners should do: DEALERS WILL REPLACE THE FUEL TANK ASSEMBLY. OWNER NOTIFICATION BEGAN MARCH 26, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT MITSUBISHI AT 1-800-222-0037.

Recall #00V421001 (12/18/2000)

  • Component: SUSPENSION:FRONT:CONTROL ARM:LOWER BALL JOINT
  • Summary: VEHICLE DESCRIPTION: PASSENGER VEHICLES. IF THE RUBBER BOOTS ON THE LOWER LATERAL ARM BALL JOINTS OF THE FRONT SUSPENSION WERE DAMAGED DURING ASSEMBLY, DIRT AND WATER CAN INTRUDE. ALSO, MMC HAS ADDED THE POTENTIAL OF LEAKING MOISTURE, WHICH CAN CAUSE THE BALL STUD TO CORRODE.
  • Consequence: THIS CONDITION COULD CAUSE THE LOWER LATERAL ARM BALL JOINT TO SEPARATE, INCREASING THE RISK OF A VEHICLE CRASH. THIS CAMPAIGN SUPERCEDES MMC'S PREVIOUS SAFETY RECALL CAMPAIGN, SEE 99V-066.
  • What owners should do: DEALERS WILL INSPECT THE LOWER LATERAL ARM BALL JOINT FOR WEAR. BALL JOINTS THAT EXHIBIT WEAR BEYOND THE ESTABLISHED TOLERANCE WILL BE REPLACED WITH NEWLY DESIGNED LATERAL ARM BALL JOINTS. BALL JOINTS THAT ARE WITHIN THE ESTABLISHED TOLERANCE WILL BE CLEANED AND A SPECIAL SEALANT WILL BE APPLIED TO PREVENT INTRUSION OF MOISTURE.

Recall #00V421001 (12/18/2000)

  • Component: SUSPENSION:FRONT:CONTROL ARM:LOWER BALL JOINT
  • Summary: VEHICLE DESCRIPTION: PASSENGER VEHICLES. IF THE RUBBER BOOTS ON THE LOWER LATERAL ARM BALL JOINTS OF THE FRONT SUSPENSION WERE DAMAGED DURING ASSEMBLY, DIRT AND WATER CAN INTRUDE. ALSO, MMC HAS ADDED THE POTENTIAL OF LEAKING MOISTURE, WHICH CAN CAUSE THE BALL STUD TO CORRODE.
  • Consequence: THIS CONDITION COULD CAUSE THE LOWER LATERAL ARM BALL JOINT TO SEPARATE, INCREASING THE RISK OF A VEHICLE CRASH. THIS CAMPAIGN SUPERCEDES MMC'S PREVIOUS SAFETY RECALL CAMPAIGN, SEE 99V-066.
  • What owners should do: DEALERS WILL INSPECT THE LOWER LATERAL ARM BALL JOINT FOR WEAR. BALL JOINTS THAT EXHIBIT WEAR BEYOND THE ESTABLISHED TOLERANCE WILL BE REPLACED WITH NEWLY DESIGNED LATERAL ARM BALL JOINTS. BALL JOINTS THAT ARE WITHIN THE ESTABLISHED TOLERANCE WILL BE CLEANED AND A SPECIAL SEALANT WILL BE APPLIED TO PREVENT INTRUSION OF MOISTURE.

View all of the recalls for Mitsubishi Galant. We will help you identify any recalls issued for your vehicle and help you find a local service center. Find a shop near you.